Outdoor LED Lamps Installation

Outdoor LED Lamps Installation

1> The models and specifications of various lamps and lanterns must meet the design requirements and national standards; the accessories are complete, and there is no mechanical damage, deformation, paint peeling, lampshade cracking and other phenomena.

2> According to the installation site and use of the led lamps, the minimum cross-section of the wires leading to each lamp shall comply with the relevant regulations.

3> When installing electrical lighting devices in masonry structures, they should be fixed with pre-embedded hooks, bolts, screws, expansion bolts, nylon plugs or plastic plugs; wooden wedges are strictly prohibited. When the design is not specified, the bearing capacity of the above-mentioned fixing parts should match the weight of the electric lighting device.

4> In more dangerous and special dangerous places, when the height of lamps and lanterns from the ground is less than 2.4 meters, lighting lamps with a rated voltage of 36 volts and below should be used or protective measures should be taken. Lamps should not be installed directly on combustible objects; when the high temperature part of the lamp surface is close to combustibles, measures for heat insulation and heat dissipation should be taken.

5> For led lamps installed outdoors, the height from the ground should not be less than 3 meters; when installed on the wall, the height from the ground should not be less than 2.5 meters.