Installing of Led floor light
Jul 21, 2022
Installing of Led floor light
1) Before installation, read the installation drawings carefully, and prepare common tools, such as flat-blade Phillips screwdrivers, hammers, etc. After unpacking the parts, it is best not to mix them up. If there are many similar parts, the drawings will draw a comparison chart of actual size, and cross out the unused parts, which is very easy to distinguish the various parts.
2) If the board is found to be damaged during inspection, you can contact the merchant to make up for it. Where the screws, eccentric parts, and wooden shafts are to be installed, guide holes will be opened, so there is no need to worry about the positioning of the parts. It should be noted that the wrong parts should not be installed and then screwed together repeatedly, otherwise the plate will be easily damaged, and the installation will often lead to instability and tilt.
3) Usually the Led floor light should have a cast iron chassis, which is slightly smaller than the surface base. The order of spare parts from bottom to top should be: chassis fastening nut, cast iron chassis, base, lamp pole, lamp holder, lampshade, plastic fastener, Light bulb.
