LED RGB Smart Strip Controller Wiring
Jul 06, 2022
LED RGB Smart Strip Controller Wiring
1) When the LED controller has three incoming wires (GND, MODE, 12V) and three output wires (B, G, R), and there are only 4 holes on the LED light and only one + sign, the wiring method First of all, the two lines of GND and MODE here represent the positive and negative poles of the power supply, and the LED controller output has four holes, so you need to carefully look at where the holes with the + sign are located in the four holes. on, specifically in the middle or on the edge.
If the + hole is on the side, connect the positive poles of the three LEDs to this hole together, and connect the negative poles of the three LEDs to the other three holes respectively.
2) On the contrary, if the + wiring hole of the LED light is in the middle position, then we can connect the positive lines of the three LEDs to the three holes of the same size and close to the hole, and finally connect the negative line. Put them together and insert them into the hole on the far side to complete the wiring of the LED controller.
3) The wiring method of the five-way LED controller, in this case, there will be three wires including the main circuit, the positive pole and the straight light, so the voltage regulator is not needed with led RGB smart strip.
